The Venti RF Suppression Sleeve is effective 400 MHz to over 30 GHz. The Venti™ sleeve addresses the unwanted EMI / RFI / PIM emissions that impact antenna signals, radio equipment and chipsets that are the heart of wireless. The Venti™ sleeve is a suppression device that can address all three forms of unwanted spurious noise traveling over the outer jacket of coax & cable without the need for an electrical connection (passive device) making the technology low cost and inexpensive to implement in the manufacturing process. Eliminating EMI/RFI/PIM at higher frequencies was previously unavailable for devices using coax & cables in high frequency devices.
What are the benefits of The Venti™ sleeve?
Greater coaxial noise suppression spurious on outer surface of outer coaxial conductor
Cleaner signal - lowering the coax noise floor from board derived interference
Greater throughput (Mbps) and longer signal range
The Venti™ RF suppression sleeve is a patent-pending solution that replaces the need for higher costing 1/4 wave chokes, stubs and ferrite cores.
The 500MHz to 30GHz frequency range opens up a whole new world for product designers and engineers that may not have been previously available. A small form replacement that replaces current EMI/RFI/PIM alternatives available today with no touch labor makes the Venti Sleeve perfect for mass-produced coax and cables.
The Venti™ sleeve is a unique EMI/RFI/PIM suppression sleeve for RF Coax/Cables for antennas, consumer electronics, computer and power cables.
The Venti™ sleeve eliminates unwanted noise traveling on the outer jacket of coax and cable (EMI/RFI) that distorts antenna patterns and effects components and devices inter-connected by cable assemblies.
The Venti™ sleeve is effective from 400MHz to 30GHz and is very low profile. The low-cost tuned Venti™ sleeve is targeted to specific frequencies and can be applied with metalized materials or paint, either by hand or automated process.
There is no need for any redesigned of coax, cables or connecting components or devices to implement the sleeve, in fact, current coax and cables can be retrofitted with the sleeve.
The Venti™ sleeve Product Line Different Sleeves - Different Applications
Compact Single Band
Tuned High Suppression
Broadband Venti™ sleeve
For Test Equipment
Without The Venti™ sleeve
With The Venti™ sleeve
Tuned RF Suppression Sleeve for Coaxial Feedlines Venti RF Suppression Sleeve for Maximum On-Air Signal
Keep RF signals on the antenna.
Prevent the return of RF signals back down feedlines.
Reduce and eliminate EMI/RFI that distort antenna patterns and reduce efficiency.
Highly Effective and Very Low Cost replacement for 1/4 Wave Closed Ended Sleeves, Stubs and Ferrite Cores.
Tuned RF Suppression Sleeve for Coaxial Assemblies
Eliminate EMI/RFI signals traveling across cables assemblies.
Reduce and eliminate EMI/RFI/PIM on coax & cable that can effect operation of connected components or devices.
Target specific frequencies – IN GHz RANGE.
Open Ended Application – No Internal Coax connection required.